■
Important-Safety Precautions
This device of which operation is subject to the following two conditions
(1) This device may not cause harmful interference.
(2)This device must accept any interference received, including interference
that may cause undesired operation.
•
To prevent fire or shock hazard, do not expose this device to rain or moisture.
Does not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
•
To avoid electrical shock, do not open this device.
•
This
device
should be operated to use only the power supply included with it
or provided as an accessory.
•
Do not overload wall outlets and extension cords as this can result in the risk
of fire or electrical shock.
•
Do not attempt to service this device yourself. Refer servicing to qualified
personnel only.
Caution:
Changes or modifications not expressly approved by the
Party responsible for compliance could void the user’s authority to
operate the equipment.
■
Note:
This equipment has been tested and found to comply with R&TTE
directive. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, if not installed and
used in accordance with the instruction, it may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
1
A. Checking Contents of Box
Checks and make sure that all of the items shown as below are included with
your 5.8 GHz Wireless A/V Sender System. If something is missing, please
contact your dealer as soon as possible.
1.
Transmitter
×
1
MPN2286AT
2.
Receiver
×
1
MPN2286AR
3.
Power adapter (optional)
!
×
2
□
230VAC to 7.5VDC
DC in Jack ( 7.5V 500mA)
4.
IR extender
mouse(emitter sensor)
to connect to transmitter
×
1
6. 3.5mm stereo plug (4 pole)
×
2
to to Scart AV cable
7.
Owner’s manual
×
1
2
