Nike HRM2400, Руководство пользователя

Страница: 20 / 24

HR transmitter does not link with the watch:
Make sure the watch has assigned a digital ID
to the HR transmitter.
See page 18.
Make sure the HR transmitter is ON by placing it on the body.
The unit turns ON when it detects the two electrodes on the
body. It is recommended to wear the transmitter directly
against the skin.
Reposition the HR transmitter slightly.
Try replacing the battery. See page 21.
Check battery placement for correct orientation. See page 21.
Moisten the electrodes with water or gel to make better
contact with the body. If you are wearing the HR transmitter
over clothing, try wetting the clothing.
Heart rate reading on watch is erratic or stops:
You may need to replace the battery in the HR Transmitter.
Sources of electromagnetic fields like appliances,
computers and power lines can cause interference.
Change your location.
This product complies with EN60601-1-2
Watch display is frozen:
The display of your watch may "freeze" due to static
electricity or recent battery replacement. If this occurs,
press and hold all four buttons at the same time.
This will erase the data in the memory and allow you
to reset the watch to the factory settings.
Watch beeps continuously:
If you have the zone alarm on and your heart rate or pace
does not fall within any of your zones, the watch will beep
to indicate you are out of your zones.
See page 10 for
instructions on how to turn off the zone alarms.
19
Troubleshooting
SDM pod does not link with watch:
Make sure the watch has assigned a digital ID
to the SDM pod.
See page 18.
Be sure the unit is ON by pressing the power switch
on the top of the unit until the LED begins to blink.
Try replacing the battery. See page 21.
Check battery placement for correct orientation. See page 21 .
LED light on SDM pod flashes rapidly:
This indicates low battery power.
Replace the AAA battery in the SDM pod.
Cross-talk:
If you receive “cross-talk” from another electronic device,
press the button on the speed sensor. The watch and speed
sensor will begin linking on another channel.
SDM pod attachment to shoe:
Make sure the SDM pod is attached to the laces securely
enough so there is no wobble when running. The pod should
be aligned with the foot and secured well enough that the
alignment does not change during run.
Orthotics:
People who wear orthotics or have extreme pronation or
supination in their stride may experience reduced accuracy.
Re-calibrate for improved accuracy.
Varying paces:
People who run at varying paces within a run
may experience reduced accuracy.
Calibrate at the speed you usually run for improved accuracy.
Press and hold all four side buttons
at the same time to reset
the watch to the factory settings.