6
OPERATION
1. Turn on the wall switch to activate the light, the light is now under nighttime mode: light and alarm work at night
only.
NOTE
: Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity.
2. To test, walk through the sensor’s detection area.
3. Movement will activate the sensor and turn the light on, the light will turn the face to the detected zone for
approx. 3 minutes.
4. After the light is activated,
keep out of detection area
and the light will switch off automatically after 3 minutes.
The light will be activated again when detecting any movement.
If there is continuing movement in the detection zone, the light will stay on until movement ceases. (after 3
minutes)
LAMP REPLACEMENT
To isolate the unit, first switch off the unit from the mains power. Allow bulb to cool before attempting to remove it.
Unscrew the lamp cover and take the old lamp out and replace with new one, close the lamp cover and tighten the
screws.
WARNING:
This fitting will become hot when in use. Allow bulb to cool before touching. Never touch the bulbs
with your bare hands. Always use a clean cloth when handling the bulbs.
NOTE: THE I NTE LLIGE NT MOTI ON SE NSOR TR ACKI NG LI GHT I S DE SI GNE D TO I LLUMI N ATE W HE N THE DE TE CTI ON
ARE A I S E NTE RE D BY A P E RSON AND W I LL DE TE CT MOV I NG HE AT S OURCE . THE RE IS NO GU AR AN TE E
IMP LIE D TH AT I T W ILL P ROVI DE TOTAL S E CURI TY OR P REVENT ILLE G AL E NTRY.
CLEANING
•
Before Cleaning make sure that the power is cut off and allow to cool before commencing.
•
Care must be taken while cleaning to avoid scratching the fitting and glass. A soft cloth or a fine hair brush
should be used with a non-abrasive cleaner.
DO NOT use solvents or abrasive cleaners on any part of the Nightwatcher.
