HR Series
Operating & Safety Instructions
English/USA – 11/09
Original Instructions
9
2.1.10
Never position any part of the Niftylift within 4.0m, (12ft) of any electrical power line, conductor or
similar not exceeding 66kV. (Minimum span 125m) Other distances for increased voltages and
different spans are given in NZECP 34:1993.
THIS MACHINE IS NOT INSULATED.
If in doubt, contact the appropriate authorities
2.1.11
On entering the platform ensure that the drop down entry bar is closed afterwards.
2.1.12
Use of an approved safety belt and lanyard, hard hat and appropriate safety clothing is mandatory.
Fasten harness to designated harness securing points within the platform and do not remove until
leaving the platform whilst in the stowed position.
2.1.13
Always remain standing within the platform. Do not attempt to increase your
height or reach by standing and/or climbing on the platform guard rails or any
other object.
KEEP YOUR FEET ON THE PLATFORM FLOOR
. Do not sit, stand or
climb on the guard rail, mid rail or boom linkage. Use of planks, ladders or any
other devices on the Niftylift for achieving additional height or reach shall be
prohibited.
2.1.14
Do not use the platform levelling system to artificially increase the outreach of the platform. Never use
boards or ladders in the platform to achieve the same result.
2.1.15
Do not use the platform to lift overhanging or bulky items that may exceed the maximum capacity or
carry objects that may increase the wind loading on the platform. (e.g. Notice boards etc.)
2.1.16
The Niftylift shall not be operated from a position on trucks, trailers, railway cars, floating vessels,
scaffolds or similar equipment unless the application is approved in writing by Niftylift Ltd in Great
Britain.
2.1.17
Always check that the area below and around the platform is clear of personnel and obstructions
before lowering or slewing. Care should be taken when slewing out into areas where there may be
passing traffic. Use barriers to control traffic flow or prevent access to the machine.
2.1.18
Stunt driving and horseplay, on or around the Niftylift, is not permitted
.
2.1.19
When other moving equipment and vehicles are present, special precautions shall be taken to comply
with local ordinances or safety standards established for the work place. Warnings such as, but not
limited to, flags, roped off areas, flashing lights and barricades shall be used.
2.1.20
Before and during driving while the platform is elevated the operator shall maintain a clear
view of the path of travel, maintain a safe distance from obstacles, debris, drop offs, holes,
depressions, ramps and other hazards to ensure safe elevated travel. Maintain a safe
distance from overhead obstacles.
2.1.21
Under all travel conditions the operator shall limit travel speed according to conditions of ground
surface, congestion, visibility, slope, location of personnel and other factors causing hazards of
collision or injury to personnel.
2.1.22
The aerial platform shall not be driven on grades, side slopes or ramps exceeding those for which the
aerial platform is rated by the manufacturer.
Содержание Height Rider 21 Hybrid
Страница 2: ......
