BA
W
-ALS 50X35_50X55 01/20 GB
Niedax GmbH & Co. KG -
Asbacher Straße 141 - D-53545 Linz/Rhein
Tel.: +49 (0 26 44) 56 06-0 - fax: +49 (0 26 44) 56 06-13 - [email protected] - www.niedax.de
DISASSeMbLy
(See fIGURe 02, 03)
Now the punching process can be started by pressing the operating switch (1.4). The opera-
ting switch has to be pressed until a clear crunch from the metal sheet, signifying the comple-
te cut, can be heard and the loose metal sheet section can be seen.
The „drive on block” of the punch on the mould is to be avoided!
Afterwards the reset lever (1.5) of the basic unit is pressed and the notching tool opens (the
punch separates from the mould).
In case the basic unit has reached the end position beforehand, it is now required to press
the reset lever more firmly.
The entire tool is now either removed from the surface metal raceway by lifting it up or moved
sideways for punching further notches.
It is not permitted to punch more than 40 notches in a row due to the risk of overheating the
hydraulic punch.
For the next use on a different surface metal raceway the nut (2.2) has to be fully loosened to
open the notching tool and tightened again after putting the notching tool in position.
No sheets of metal should remain in the mould of the notching tool. If there are they must be
removed.
• When disassembling the notching tool it is absolutely necessary to
remove the battery
(1.3) of the drive / basic unit.
• Afterwards the notching tool can be unscrewed from the basic unit via the threaded bolt
(2.1).
• The inner gear of the basic unit doesn’t have a self-locking capacity.
• Because of this it is possible for the gear of the basic unit to turn with the motion of
unscrewing the notching tool and making disassembly impossible.
• In this case the battery has to be inserted again.
•
CAUTIoN: Risk of injury, keep hands out of the area of the notching tool!
• Then the operating switch (1.4) is activated until the end position is reached. Afterwards the
battery is removed. Now the gear of the basic unit (1) is blocked and the notching tool (2)
can be unscrewed. Once this is done, the reset lever has to be pushed for the gear to be
loosened again by the hydraulic system.
7
/8
