22
SI-Ethernet User Guide
Issue: 3
5.10
Single line parameter descriptions
Table 5-3 lists the coding used for the parameter type in the subsequent parameter description
tables.
Table 5-3 Parameter type coding
5.10.1
Internal menus
The Ethernet interface provides parameters for configuration and information, these parameters
are grouped into menus as shown in Table 5-4
Table 5-4 Ethernet internal menus
RW
Read /
Write
RO Read-only Bit
Bit
parameter
Txt Text string Date
Date
parameter
Time
Time
parameter
Chr
Character
parameter
Bin
Binary
parameter
IP IP address Mac
MAC
address
Ver
Version
number
SMP
Slot, menu,
parameter
Num
Number
parameter
DE Destination ND
No default
value
RA
Rating
dependent
NC
Non-
copyable
PT
Protected
FI
Filtered
US User save PS
Power-
down save
BU
Bit default
or Unipolar
Menu
Name
Description
S.0
Module Setup
Provides module information such as firmware version, serial number and
status
S.2
Ethernet
Configures and provides information on the Ethernet network
S.9
Resources
Provides information on the module task resources and PCB temperature
S.10
Easy Mode
Configures and provides information on the Easy Mode cyclic data setup
S.11
Synchronization
Configures and provides information on the module synchronization
S.15
Modbus
Configures the Modbus protocol features
S.20
EtherNet/IP
Configures and provides information on the EtherNet/IP protocol
S.21
EtherNet/IP IN
Configures the EtherNet/IP input mappings (PLC to Drive)
S.22
EtherNet/IP OUT
Configures the EtherNet/IP output mappings (Drive to PLC)
S.23
EtherNet/IP Fault
Values
Configures the EtherNet/IP values to write under a network loss condition
Содержание Unidrive M600
Страница 1: ...User Guide SI Ethernet and Unidrive M Onboard Ethernet Part Number 0478 0137 03 Issue 3 ...
Страница 16: ...16 SI Ethernet User Guide Issue 3 Figure 4 3 Typical network topologies ...
Страница 215: ......
Страница 216: ...0478 0137 03 ...