Commissioning
EN - 30 of 39
3.4.3 Configuration of Outputs
The EKE10 provides two programmable digital outputs, OUT1 and OUT2.
3.4.3.1 Programming of the Output Functions
Caution
The dry contacts are solid state relays (Photo-MOS) with 30Vcd maximum
voltage. When using external supply, the voltage must not exceed the limits
given at the Technical Data page. Otherwise the relays may be destroyed.
Note
The speed impulse function can only be programmed to one output. If
programmed to both outputs, only OUT2 will be used.
Register
Value
Description
Properties
0
Output OFF
Output stays always OFF (open)
1
Error output signal
Low-active
Closed: no error
Open: error
2
Running signal N > Nmin
Nmin = rpm
3
Running signal N = Nset
Tolerance 5%
4
Speed impulse
1 impulse per motor revolution (50% High, 50% Low)
5
Output ON
Output stays always ON (closed)
Table 15: Configuration of outputs with register Config_OUT
