Nice HSDOM21, Руководство по установке

Страница: 4 / 52

2 - English
EN
HSDOM21 transmits signal to the control unit around every
40 minutes to indicate that the system is running; this is nec-
essary for the “supervision function” on the control unit.
2 - INSTALLATION
Warnings
• Locate the position and height for fixing HSDOM21, ac -
cording to the protection area required: refer to fig. 2 .
• Carefully check the form of the area to be protected; if in
doubt, before making the final fixture, temporarily secure
the product and perform some tests and make adjust-
ments as required.
• The special design of the infrared sensor lens creates a
sensitive “curtain” area. If
the detector is positioned
vertically, the sensitive area
is horizontal (parallel to the
ground); if the detector is
positioned horizontally, the
sensitive area is vertical
(curtain protection with bar-
rier effect).
It is important to carefully evaluate these factors ac cording
to the area to be protected, in relation to possible insensi-
tivity to animals and considering the risk of rapid transit
through the area.
• If the product is to be installed in a corner, the directional
joint model HSA3 should be used (optional accessory):
Caution! – Use of the joint partly reduces efficiency of the
anti-removal protection, as the magnet remains on the
bracket. If the magnet is not used, the protection must be
inhibited by setting
dip-switch 5 to ON .
01. Select the bracket fixture position, ensuring that it is
compatible with the overall dimensions of the detector: it
must be possible to access the release lever (
fig. 3 ) with
sufficient clearances to connect and disconnect the
detector.
02. A – Wall-mounting: drill two holes for insertion of the
wall plugs and a hole for the magnet, used for the anti-
removal protection. Then secure the bracket by means
of the plugs (
fig. 4-A );
02. B – Corner-mounting with directional joint mod.
HSA3: fix the joint to the wall (see relative instruction
manual), then secure the bracket to the joint as shown in
fig. 4-B ;
03. Open the housing by loosening the 4 rear screws ( fig. 5 );
04. Set the control unit to learn HSDOM21 (see control unit
instruction manual);
05. Open the battery compartment as shown in fig. 6 and
remove the insulation tab keeping the batteries discon-
nected: HSDOM21 emits two series of 3 beeps and
starts programming in self-learning mode; this is con-
firmed by 1 beep emitted by the control unit (4 beeps
indicate that the device is already programmed).
06. Program the dip switches ( fig. 7 ) and set the trimmers
( fig. 7 ) with reference to chapter 3 - Programming; then
perform the operation “ Test ” , see paragraph 3.1.
07. Close the housing ( fig. 8 ) and connect the HSDOM21 to
the fixing bracket ( fig. 9 ).
3 - PROGRAMMING
HSDOM21 is equipped with 5 dip-switches ( fig. 7 ) which
enable programming of a number of operating parameters
vertical horizontal