4.2 - Memorising transmitters in Mode I
When there is no transmitter memorised, the first can be memorised during startup according to the following procedure.
Table A2 - Memorising first transmitter during startup in Mode I
Example
01.
Connect the control unit to the power mains, confirmed by 2 red flashes.
02.
Within 10 seconds:
•
Monodirectional transmitters:
press and hold any key of the transmitter to be memorized for at
least 3 seconds.
•
Bidirectional transmitters:
press any key of the transmitter to be memorized
MONO:
3s
BIDI:
03.
If the memorisation procedure is successful, the LED emits 3 red flashes.
If no transmitters should be memorized during startup, the programming procedure concludes automatically after 10 seconds and the LED
emits one long red flash.
The transmitters can be memorised using the programming pushbutton according to the following procedure.
Table A3 - Memorising first and other transmitters in Mode I
Example
01.
Press and hold the programming pushbutton (fig. 1).
02.
Release the programming pushbutton (fig. 1) when the LED illuminates with
red
color (1st position).
03.
Within 10 seconds:
•
Monodirectional transmitters:
press and hold any key of the transmitter to be memorized for at
least 3 seconds.
•
Bidirectional transmitters:
press any key of the transmitter to be memorized
MONO:
3s
BIDI:
04.
If the memorisation procedure is successful, the LED emits 3 red flashes.
05.
Repeat steps 3 and 4 to acquire all the remotes.
06.
After 10 seconds that the device doesn’t receive any signal, the programming procedure concludes
automatically.
If transmitters have already been memorised, other transmitters can be memorised as described in the following procedure.
Table A4 - Memorising other transmitters with a previously memorised transmitter in Mode I
Example
01.
Press any key three times of a
previous
, memorised transmitter.
Old
x3
02.
Press the same key three times of a
new
transmitter.
New
x3
03.
Press the same key three times of a
previous
, memorised transmitter.
Old
x3
04.
Press the same key of the
new
transmitter.
New
05.
If the memorisation procedure is successful, the LED emits 3 red flashes.
06.
The programming procedure concludes automatically.
Note.
If the memory is full (30 transmitters memorised) 6 red flashes are emitted and the transmitter cannot be memorised.
