8
– English
English
3.3 - INSTALLATION OF OTHER EQUIPMENT
The AVIO500 installation is made up of three parts:
- Guide assembly (see paragraph 3.3.1).
- Fixing of the gearmotor to the guide (see paragraph 3.3.2).
- Fixing of the gearmotor to the ceiling (see paragraph 3.3.3).
3.3.1 –
ssem ling t e guide
The guide supplied with the AVIO500 must be assembled as follows:
1.
Referring to figure 14, remove the belt tensioner device (14a); insert
one end of the belt into the pulley (14b); reintroduce the belt tensioner
device into the guide (14c).
2.
Pass the same end of the belt through the head
[A]
, as in figure 15.
NB - Make sure that the belt is correctly positioned: it must be with
the teeth facing inwards, straight and without twists.
3.
Turn the lower section of the carriage so that the grooves correspond
ith the t o ends of the belt, as in figure 16.
4.
Place both ends of the belt into all the shaped slots of the lower car-
riage
[B]
. Secure the ends of the belt with the 2 screws (V4.2x9.5)
and 2 ashers (R05), as in figure 17.
5.
Fix the belt guide
[C]
to the upper carriage
[D]
with the V6x18 screw
and related M6 nut, as in figure 18.
6.
Insert the upper carriage
[D]
into the lower carriage
[B]
and place the
entire carriage assembly inside the guide, as in figue 19.
7.
With the aid of a hammer, assemble the three pieces of the guide
engaging them into the connection brackets
[E]
, using the hammer,
per figures 20 and 21.
m ortant
– the guides must slide inside the brackets until they click
firmly into place.
8.
Carefully position the belt into the guide, making sure that it is not twisted.
9.
Fix the head
[A]
into the free end of the guide ith force, as in figure 22.
10.
Finally, tension the belt with the adjustment screw
[F]
of the belt ten-
sioner device. See fig. 23.
Caution - the gearmotor could break if the belt is TAUT, and it
could cause unpleasant noise if it is too SLACK.
16
3.3.2 –
i ing t e gearmotor to t e guide
1
Couple the AVIO500 gearmotor’s shaft extension with the head of the
guide
[A]
; then secure them using the four M6.3x38 screws
[G]
.
24
A
G
1
2
3
4
14b
14c
14a
15
A
18
D
C
22
A
19
D
B
17
B
20
21
E
F
23
