Nice Apollo 4300SW, Руководство пользователя

Страница: 18 / 46

16
11.8 - The learning sequence
Once the limit switches are all set, the final step is to LEARN the control
board. To perform this task, follow the below listed steps:
1. The control board is already in the “LEARNING MODE” when shipped.
In any case follow steps of section 6.9 in order to select the most
appropriate kind of gate according to the installation. Press “OK” to allow
the control board to scan for attached items, such as sensors, photo-
eye’s and other safety devices.
2. The gate will open partially, then stop. This is being done, so that the
control board can sense the type and operational condition of the drive
motor. The gate will then run to the closing limit, so that it can properly
sense where it is located.
3.
The control board will then OPEN the gate slowly to establish travel and
limits.
4.
Once the gate reaches the fully OPENED limit switch, the control board
will now increase gate travel speed to the highest speed allotted, and will
now travel to the fully CLOSED position at full speed.
5.
The gate opener is now programmed for basic usage.
11.9 - Learning mode
If not in learning mode, follow the below listed steps;
Steps on how to place the NICE 1050 control board into learning mode.
If the board is not in “LEARN MODE”, press:
FUNCTION

OK

SWING

OK

LIGHT

OK
AVERAGE
HEAVY
You are in LEARN MODE if “ENTER” is flashing.
For dual gate installations - set one motor at a time.
11.10 - Gate Reversal Direction
WARNING: GATE DIRECTION REVERSAL CAN ONLY BE
ACCOMPLISHED IN LEARNING MODE
Gate Direction Reversal
If for some reason, the installer were to install the opener on the opposite
side of the gate from which the unit is programmed, and when you press the
“OPEN” button, the gate actually CLOSES, the installer will need to REVERSE
the direction of travel to match the buttons on the control board.
Press “OPEN” and note if the gate actually opens. If it does not, and instead is
traveling in a CLOSING direction follow the below steps to correct; (if already
in learning mode, follow the below listed steps).
1. Press FUNCTION
2. Scroll through the options to reach “ADVANCED SETTINGS”
3.
Press ENTER
4. Scroll through selection to reach “DIRECTION OF MOTOR”
5. Press ENTER
6.
The direction arrows on the display begin to blink.
7. Choose the appropriate direction of travel
8. Press DISPLAY to return to the MAIN MENU
9. Press OPEN to verify that the gate now OPENS.
Learn
Enter
“Enter” Flashes
Figure 10 - LCD DISPLAY
5
6
3
1
2
4
7
Figure 11 -Open Learning
11 - INSTALLATION PROCEDURES (CONT.)