13
The control board is already in the “LEARNING MODE”
when shipped. If the board is not in “LEARN MODE”
press FUNCTION then select LEARN then SWING then
LIGHT, AVERAGE OR HEAVY, then press ENTER.
For dual gate installations - set one motor at a time.
Using the MANUAL RELEASE, disengage the drive motor.
Move the gate manually (with your hands) to ensure that the
gate travels to the fully open and fully closed positions with
no binding or problems. Gate should move freely.
If there is no binding present and the gate will fully open and
close manually without problems. Manually move the gate
mid-way and engage mechanical release.
15 - LIMIT SWITCH ADJUSTMENT
Test motor direction by pressing OPEN. If the gate instead
CLOSES swap the RED and BLACK motor leads.
Using the OPEN button on the front of the Control board,
hold the button down until the gate reaches the fully intended
open position.
Adjust the Open Limit Switch until the GREEN light
illuminates on the front of the control board. The FULLY
OPEN limit switch is now set.
MOTOR 1 LED - GREEN
MOTOR 2 LED - GREEN
The open and close limit switches are located on the top of
the motor assembly. Adjustments are made by loosening the
limit cam bolt and turning the limit cam by hand. Once the
proper limit switch has been activated tighten the bolt back
down to secure the cam in place.
Using the CLOSE button on the front of the Control Board,
hold the button down until the gate reaches the fully intended
closed position.
Adjust the Closed Limit Switch until the RED light illuminates
on the front of the control board. The fully CLOSED limit
switch is now set.
MOTOR 1 LED - RED
MOTOR 2 LED - RED
Once all adjustments have been made, reinstall the cover
on the motor assembly and secure in place with screws
provided.
16 - REPLACE COVER
