doc.000 012018 5/7
For Solid Concrete Floors only (see Fig. 4)
Using a 7 mm diameter masonry drill, drill through all the
holes in the base, then remove the base and increase each
hole to a diameter of 10 mm and to a depth of 85 mm.
Clear the dust from the holes using a vacuum cleaner and
insert the nylon plug until the top is in level with the floor.
(see Fig. 4)
For Wooden Floors only (see Fig. 5)
Only install the Autolift electric on to a wooden floor if the
floor boarding is 12 mm or more thick.
Using an 8 mm diameter drill, drill through the centre of all
the holes in the base.
Slight repositioning of the base may be necessary to avoid
joints or nails in the floorboards.
If the drill has to enter a joist then drill the hole to a depth of
70 mm. (see Fig.6)
Note: If the expansion anchor enters a joist, tightening
the screws will still ensure a secure fixing.
For increased security, the floorboards must be
screwed down to the joists in the vicinity of the
base with appropriate wood screws.
Using the fixing screw insert each nylon expansion anchor in
position.
Remove the fixing screws leaving the expansion anchor in
position.
Note: The anchor may have to be lightly tapped in to
'bed in' the small taper wedges on the top of the anchor.
Содержание Autolift electric
Страница 1: ...Installation instructions...
