NI VXIpc-882 Installation Guide
2
ni.com
3.
Insert the controller in the desired slot by aligning the top and bottom
of the controller with the card-edge guides inside the chassis. Slowly
push the controller straight into the slot until its plug connectors are
resting on the backplane receptacle connectors. Using slow, evenly
distributed pressure, press the module straight in until it seats in the
expansion slot. The front panel of the controller should be even with
the front panel of the chassis.
4.
Tighten the retaining screws on the top and bottom edges of the front
panel.
5.
Check the installation.
6.
Connect the keyboard and mouse to the USB connectors.
Note
Install a noise-suppression ferrite (included in your shipping kit) onto the external
USB cable when using a USB mouse or keyboard to ensure that your device meets all EMC
standards applicable to your country. For more information on installing the ferrite, refer
to KnowledgeBase 4Q0899P6 at
ni.com
.
7.
Connect the DVI-I monitor video cable to the DVI-I connector.
8.
Connect devices to ports as required by your system configuration.
9.
Replace or close any doors or covers on the chassis.
10. Power on the chassis.
11. The controller should now boot. If the controller does not boot, see
What if the NI VXIpc-882 does not boot?
section.
12. On the first boot of the controller, a setup program automatically runs.
13. Follow the prompts in the setup program to fully configure your
controller.
14. When prompted for the Windows serial number, enter the serial
number of the operating system from the included certificate.
15. Your controller is now ready for development.
