NI SCXI-1127, Руководство пользователя

Страница: 28 / 44

Chapter 1 Installing and Configuring the SCXI-1127
Consult the documentation for your SCXI chassis and other SCXI modules
for additional instructions and warnings. Any non-SCXI-1127 modules
should already be installed according to their installation instructions. To
set up the SCXI-1127 module to be accessed by a DAQ device via another
SCXI module, follow these steps while referring to Figure 1-9.
1. Y o u should have already installed the SCXI-1127 modules and their
HVAB-backplane adapters (1357/1358) according to the instructions
found earlier in this chapter.
2. Connect the MIO/DIO cable adapter to the rear of a module that is not
the SCXI-1127 module. Secure the adapter to the SCXI chassis using
the screws provided.
3. A t t a c h your DAQ cable to the cable adapter at the rear connector.
4. A t t a c h the other end of the DAQ cable to the National Instruments
DAQ device.
5. C h e c k the installation.
6. T u r n on the SCXI chassis.
7. T u r n on the computer or reconnect it to your chassis.
8. I f you already have the appropriate software installed, you are ready to
configure the SCXI-1127 via an SCXI module other than the
SCXI-1127 module.
© National Instruments Corporation 1-17 S C X I - 1 1 2 7 User Manual