SCB-8 Interior
Refer to the following figure for information about the interior of the SCB-8 when
connecting the SCB-8.
Figure 3. Interior of the SCB-8
2
2
3
0
GND
GND
J2
J3
1
2
1
2
1 2 3 4
DIO
5 6 7
+5 V
1
1. 0.1 inch dual row header
2. Wall mounting screw holes
3. Cable tie loops
Connecting the SCB-8
Complete the following steps to connect and use the SCB-8 with NI hardware.
Install your NI hardware in a chassis. Refer to the hardware documentation for your
product(s) for installation instructions.
1. Remove the four cover screws with a Phillips #1 screwdriver and open the top
cover, as shown in Figure 1.
Caution
Refer to the documentation for the hardware you connect
the SCB-8 to for maximum voltage specifications. Using voltages
outside of the specified range could damage the SCB-8 and any
instruments connected to it. NI is not liable for any damage resulting
from using voltages outside of the recommended range.
© National Instruments
5
SCB-8 Features
Содержание SCB-8
Страница 1: ...SCB 8 Features 2022 07 11...
