2.
In the configuration tree, double-click
Devices and Interfaces
to see the list of installed
devices.
Note
If you are using the NI 5673E with the LabVIEW Real-Time Module,
expand
Remote Systems
. Find your target IP address or name, expand it, and
then expand
Devices and Interfaces
.
Installed devices appear under the name of their associated chassis.
3.
Expand your
Chassis
tree item.
MAX lists all devices installed in the chassis. Your default device names may vary.
Note
If you do not see your device listed, press <F5> to refresh the list of
installed devices. If the device is still not listed, power off the system, ensure
the device is correctly installed, and restart.
4.
Record the device identifier MAX assigns to the hardware. Use this identifier when
programming the NI 5673E.
5.
Associate the hardware modules that comprise your device.
a)
Select the NI 5611 that is identified as not configured in the configuration tree.
b)
In the Associated Devices section, select the appropriate module from each system
component drop-down listbox.
For the NI 5673E, you must associate the NI 5611 I/Q modulator module with the
NI 5450/5451 AWG module and the NI 5650/5651/5652 LO source module.
c)
Click
Save
in the MAX toolbar.
Note
Module associations may be lost when you move the modules to
different chassis slots.
6.
Self-test the device modules by selecting the modules in the configuration tree, and
clicking
Self-Test
in the MAX toolbar. Repeat this step for all modules in your NI 5673E
system.
The MAX self-test performs a basic verification of hardware resources.
Related Information
Interconnecting the NI 5673E Modules
on page 8
18
|
ni.com
|
NI PXIe-5673E Getting Started Guide
