GPIB Hardware Installation Guide and Specifications
|
© National Instruments
|
13
Baseplate Identification Label
When you configure the GPIB-ENET/1000 for use on your network, you will need to
differentiate it from other network devices. Every GPIB-ENET/1000 has a unique serial number,
Ethernet address, and default hostname. You can find this information on the baseplate
identification label on the GPIB-ENET/1000.
Note
The Ethernet address is not the IP address. All devices on an Ethernet network
are assigned a unique physical address—the Ethernet address, also known as the
MAC address—so they can communicate with each other.
Figure 7.
GPIB-ENET/1000 Baseplate Identification Label
Startup
Turn on the front-panel power switch. The
POWER
LED lights steady green. The
READY
LED blinks green rapidly while the GPIB-ENET/1000 completes its boot process and attempts
to acquire its network parameters.
By default, the GPIB-ENET/1000 attempts its network configuration automatically through
DHCP. If there is no DHCP response, the GPIB-ENET/1000 reverts to Auto IP addressing and
assigns itself an IP address in the range of
169.254.
x
.
x
for more
information. The time required for assigning the IP address depends on your network and the
configuration of your GPIB-ENET/1000. Allow up to 30 seconds and observe the state of the
READY
LED to determine the outcome of the boot process. One of the following should occur:
•
A steady green
READY
LED indicates the GPIB-ENET/1000 finished the boot process
and acquired its IP address. The unit is now ready to operate. When using DHCP, the
GPIB-ENET/1000 typically is ready to operate about 15 seconds after you power it on.
•
If the
READY
LED blinks a slow red pattern, the GPIB-ENET/1000 boot process failed.
to interpret the flash pattern before calling National
Instruments Technical Support.
•
A steady red
READY
LED indicates that the GPIB-ENET/1000 has corrupt firmware and
has entered Safe Mode. The only operation allowed in Safe Mode is to update the firmware.
Refer to the
section for instructions on how to update the firmware.
1
Serial Number
2
MAC Address (Ethernet Address)
3
Default Hostname
N114
1
2
U.S.A.
Prod. of
196541B-01L
BA5BF1
MODEL: GPIB-ENET/1000
PART NO:
SERIAL NO:
MAC ADDRESS: 00802F090E97
DEFAULT HOSTNAME: NIENET BA5BF1
1
REV:
40
3
