3.
LabVIEW FPGA Module 2014 or later
1
4.
NI-RIO Device Drivers 14.0 or later
For minimum software support information, visit
swsupport
.
Installing C Series Modules
Complete the following steps to install a C Series module.
2
2
3
1
1.
Verify that power is not connected to the I/O connector(s) on the C Series module. If the
system is in a nonhazardous location, the cRIO-9067 can be powered on when you install
modules.
2.
Press the latches on the C Series module.
3.
Align the C Series module with a slot and seat it in the slot until the latches lock in place.
Removing C Series Modules
Verify that power is not connected to the I/O connector(s) on the C Series module before you
remove a module from the cRIO-9067. If the system is in a nonhazardous location, the
cRIO-9067 can be powered on when you remove modules.
Connecting the cRIO-9067
The cRIO-9067 has the following connectors, LEDs, and buttons.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9067, LabVIEW FPGA Module is required.
NI cRIO-9067 Getting Started Guide
|
© National Instruments
|
5
