cRIO-9052 Operating Instructions
4
ni.com
Required Components
You must have the following components installed and configured to use
the cRIO-9052:
•
cRIO-9052
•
Laptop (CardBus), PC (PCI), or PXI chassis you will use to interact
with a Compact RIO reconfigurable chassis
•
A CompactRIO reconfigurable chassis (cRIO-91
xx
)
•
NI 8310
•
Power supply (9 V to 35 V)
•
Two shielded CAT5 Ethernet cables
•
Six ferrites (two for each CAT5 cable and two for each power supply
input)
Cabling
The transmit and receive cables must be within 2.54 cm (1 in.) of the same
length. The maximum cable length is 14 m (45.93 ft.).
To ensure that the device or system passes the emission standards in your
area, you must install a ferrite at each end of both CAT5 Ethernet cables and
on each of the power supply inputs, and thus you need six ferrites.
NI provides accessory kits that include the appropriate length CAT5
Ethernet cables and required ferrites. Visit
ni.com
and search for one of
the part numbers listed in Table 1 for more information about these kits and
to purchase them.
Table 1.
National Instruments Cable Sets
Cable Length
(m)
Description
Orderable
Part Number
1
Cable
Part Number
2
3 m
3 m StarFabric Cable Set
CBL3S-NI
779544-03
763640-03
10 m
10 m StarFabric Cable Set
CBL10S-NI
779544-10
763640-10
14 m
14 m StarFabric Cable Set
CBL14S-NI
779544-14
763640-14
1
This is the part number you use to order the cable kit from NI.
2
This is the part number that appears on the cable.
