NI CB-2162, Руководство пользователя

Страница: 16 / 23

NI CB-2162 User Guide 16 ni.com
Connecting Power
Caution NI is not liable for any device damage or personal injury resulting from improper
connections that exceed the maximum specifications of the NI CB-2162.
To provide power to the prototyping area, connect V
CC
from a DC power
supply to J3 (red terminal) and ground to J4 (black terminal). Refer to the
Specifications section for the acceptable voltage ranges.
The green power LED is lit when a positive voltage is applied to the
NI CB-2162. However, if negative voltage is applied, the Power LED does
not light. The power connectors and LED for the prototyping area are
labeled in Figure 1.
Prototyping Circuits
The prototyping area of the NI CB-2162 consists of 304 through-hole
solder pads—208 isolated pads for component mounting and wire
connections, 48 pads connected to V
CC
, and 48 pads connected to
ground—and space for attaching surface-mount components.
Refer to the Specifications section and to the NI digital waveform
generator/analyzer modules specifications for information on the voltage
limitations on circuits created in the prototyping area.
Replacing Components
The NI CB-2162 does not use replaceable fuses. If you need to replace the
LED, choose a replacement that meets the specifications described in the
Specifications section.