7.
The recommended software set is preselected from the list of software add-ons. Check
any additional software add-ons you want. The System State Publisher, for example,
makes monitoring system performance simple.
Note
You can use the LabVIEW Real-Time Software Wizard to install more
software add-ons later. The FlexRIO 15.0 Recommended Software Set is
enough to get started.
8.
Click
Next
.
9.
Review the summary of software to install. Click
Next
to begin the update.
10. Wait for the installation to finish, and then click
Finish
.
Adding the NI-7935R to a LabVIEW Project
1.
Launch LabVIEW. The LabVIEW
Getting Started
window appears.
2.
Click
Create Project
or open an existing project.
3.
Right-click the project root in the
Project Explorer
window and select
New
»
Targets
and Devices
from the shortcut menu to display the
Add Targets and Devices
dialog box.
a)
If the hardware is connected to the host, select
Existing target or device
. Select the
NI-7935R under
Real-Time FlexRIO
and click
OK
.
b)
If the hardware is not connected to the host, select
New target or device
. Select the
NI-7935R under
Real-Time FlexRIO
and click
OK
.
4.
Right-click the target and select
New
»
FPGA Target
.
The FPGA target appears in the project under the Real-Time target.
Adding a FlexRIO Adapter Module to the Target
Skip this section if you are not using an adapter module.
1.
Expand the FPGA target by clicking the
+
button, then right-click
IO Module
and select
Properties
.
2.
Select the
General
category and check the
Enable IO Module
box.
3.
Select your I/O module from the
IO Modules
list, and select the CLIP you want to use
from the
Component Level IP
box.
4.
Click
OK
.
Programming Options
Refer to the following table for information about how to program the NI-7935R.
Component
Programming Option(s)
Real-Time controller LabVIEW Real-Time or C/C++ Development Tools for NI Linux
Real-Time, Eclipse Edition.
FPGA
LabVIEW FPGA
NI-7935R Getting Started Guide
|
© National Instruments
|
11