Nexxt Solutions - ACRUX - Wireless N Gigabit Router
16
Chapter 3. Quick Installation Guide
This chapter will show you how to configure the
basic functions of you Wireless N Gigabit Router in
minutes using the Quick Setup Wizard.
3.1 TCP/IP Configuration
The default IP address of the router is
192.168.0.1. And the default Subnet Mask is
255.255.255.0. These values can be changed as
you desire. Default values are used in the descrip-
tion included in this manual.
Connect the local PC to the LAN ports of the router.
You can now start configuring the IP address for
your PC as described below.
Configure the IP address manually.
Obtain an IP address automatically.
The user can now run the Ping command in the
command prompt to verify the network connec-
tion between your PC and the Router. The following
Set up the TCP/IP Protocol for your PC. If you
need further instructions regarding this feature,
please refer to Appendix B: “Configuring the PC.”
Configure the network parameters. The IP address
is 192.168.0.xxx (“xxx” is any number from 2
to 254), Subnet Mask is 255.255.255.0, and
Gateway is 192.168. 0.1 (The router’s default IP
address).
Set up the TCP/IP Protocol in “Obtain an IP
address automatically” mode on your PC. If you
need further instructions regarding this feature,
please refer to Appendix B: “Configuring the PC.”
The built-in DHCP server will then assign an IP
address to the PC.
1.
2.
1.
2.
*
*
Содержание Acrux3000
Страница 1: ......
