NexWatch PW-5000 PW5K1EN, Руководство по установке

Страница: 10 / 14

PW5K1EN Ethernet Daughter Installation Guide
10 TD1120 rev1101
P
ROGRAMMING
E
THERNET
D
EVICES
This covers all of the steps needed to get the LANSRL100 and the
PW5K1EN Ethernet Daughter on-line and working. Programming
of these units will be outlined below based on EZWebCon version
1.1/7. The LANSRL100 and the PW5K1EN will be referred to as
"MSS" or "MSS Device"
EZWebCon Programming
The MSS Device must have an IP address before you can log into
it using EZWebCon. To assign the IP address from EZWebCon:
• Install EZWebCon utility. The EZWebCon executable can be
found on the software installation CD.
Execute EZWEBCON.EXE setup file from the supplied CD.
Install the application to the local drive. When the program
has been installed, execute the application.
• Click on the Lantronix logo menu in the bottom left corner of the
EZWebCon window, then select Assign IP Address to Server.
• Fill in the following information:
• The last three bytes of the MSS's hardware address. The hard-
ware address is printed on the rear/bottom of the MSS Device.
• The desired IP address.
• The default subnet is 255.255.255.0. (uncheck the None box).
• Check "Automatically connect and permanently assign the IP
address to server".
• Click OK.
• Cycle power on the MSS Device. EZWebCon will let you know
whether the configuration was successful.
After the MSS Device has been programmed with an IP address,
the parameters of the unit can be addressed.
From the main menu of the EZWebcon software, select the
"Micro-Serial Servers" icon in the lower right-hand corner of the
menu. The software will now attempt to establish communications
to the MSS Device. Click Browse and select your IP address
defined above. Click OK and OK again on MSS Management
screen.
When communication has been established, the MSS
Management Menu will appear. This menu will allow the user to
program, download, save, and monitor the MSS Device.To begin
programming the unit, click on the "Interview Wizard" icon. This
wizard will walk through the configuration of the MSS Device.