Toll Free: (866) 501-1683 / Phone: (905) 458-5455 / Fax: (905) 458-5484
Page 25 of 38
4.2
4.2
4.2
4.2
POWER TROWEL BLADES
POWER TROWEL BLADES
POWER TROWEL BLADES
POWER TROWEL BLADES
The NXT-90 comes equipped with four (4) reversible, 6-inch x 14-inch (15.25cm x 35.5cm)
finishing blades (see Figure 15). The special trowel steel of each blade will provide your
concrete with a quality finish. These blades will wear down with use; each blade can be
reversed when the first edge is no longer providing the desired finish quality. When both
edges have been expended, it is time to replace the blade. Refer to the Parts Catalogue
for part numbers and ordering information.
Do not let your Power Trowel sit motionless in wet concrete for extended
periods. The blades will become stuck as the concrete cures and can
damage the drivetrain upon restart. If your Power Trowel does become
stuck, work the blades free by leaning it in several directions.
FIGURE 1
FIGURE 1
FIGURE 1
FIGURE 15
5
5
5:::: TYPICAL FINISH BLADE
To reverse a blade, follow these steps:
1.
Raise the NXT-90 above the floor by putting blocks under the safety ring or by
suspending it by the hoist hook on the folded handle. Work away from the wet
concrete or any grates where small parts can be lost.
2.
Loosen the inner and outer retaining bolts using a wrench. Loosen the inner bolt to
the point that it can be removed (see Figure 16).
FIGURE 1
FIGURE 1
FIGURE 1
FIGURE 16
6
6
6:::: LOOSEN BLADE RETAINING BOLTS
