Nexus FDX-kit, Инструкция по установке и эксплуатации

Страница: 20 / 50

NexusRace SW English
19
6.1.2 Damping settings
The damping of the displayed data is selectable from the either the Multi Control
instrument or in the Configure box. The damping can either be local (different on each
instrument) or global (same damping on all instruments. The factory setting is global.
The damping is selectable in 10 steps 0-9 and the damping time (for how long an
average value is calculated) is as follows:
D0 raw data, no averaging
D1 2 second
D2 4 seconds
D3 6 seconds
D4 8 seconds
D5 10 seconds
D6 14 seconds
D7 18 seconds
D8 25 seconds
D9 30 seconds
To change damping from the instrument, go to the function you want to change
damping for. If it is a main function, you press SET and PLUS together and if it is a sub
function, you press SET and MINUS together.
The selected value for the damping is displayed next to the function. Change to the
new value with PLUS or MINUS and confirm with SET.
If the value is written with a capital D, the damping is global and all instruments will be
set to the same damping. If the damping is written with a lower case d the damping is
local and only this instrument is affected.
6.1 Setup the NXR Multi Control Instrument
If you right click on the NXR Multi instrument and select Setup, the Instrument property
box pops up.