11
CHARGING THE RECHARGEABLE BATTERY
NSB-25 INTERFACE
12
The battery can be charged using the AC power adapter unit delivered with this
product.
●
Turn off the NSB-25
●
Connect the charger’s wall plug to the NSB-25’s "DC IN" slot
●
Plug the AC power adapter unit into a wall socket
●
The LED above the control key shows red when charging
●
When the battery is charged, the red LED turns off.
●
When error occurs during charging with LED blinking, unplug the AC adapter
unit and plug it in again.
Users can also charge the NSB-25 via the USB3.0 cable.
With a completely empty rechargeable battery, the charging procedure lasts
approximately 6 hours using the AC power adapter. With the USB 3.0 cable, it takes
about 12 hours to charge completely.
When the battery goes flat, warning message will be displayed on LCD and the
power will be off. When it occurs during the backup, the copy may be incomplete.
And you should check the backup result. When the device is switched on again,
the previous backup status will be displayed; either “Success” or “Failed”.
8. Charging the Rechargeable Battery
9.1. Turning the NSB-25 on/off
9. NSB-25 Interface
Press the power key on the right side of
the device for a few seconds in order to
turn the NSB-25 on. The power up logo
and firmware version will be shown on
the LCD. When you see the logo on the
LCD screen, release the button.
Otherwise, the NSB-25 will automatically
power off.
After checking the system, the NSB-25
goes into [XCopy/MCopy ready] mode.
You can copy a memory card in this mode.
The NSB-25 will automatically turn off
when not in use. The user can choose the
amount of idle time (e.g. 30/40/50/60/90
seconds) prior to an automatic power off.
The NSB-25 can be powered off by
pressing down on the power key for more
than 1 second. For details on Setting Auto
Power Off, see chapter 19.
Reference
●
You must turn off the NSB-25 in order to charge the unit.
●
The NSB-25 can be charged via USB without using the AC power adapter
included in the box. A high powered USB connection is needed, i.e. a USB
connection with its own power supply, such as the USB port of a computer or
a USB hub with a power unit.
●
Always keep the battery charged one or more of the gauge remaining on LCD.
If the battery is completely discharged, it shortens the batteries life.
●
If the NSB-25 battery is completely discharged, the performance of the battery
may be degraded. It is recommended that the NSB-25’s battery be recharged
before the battery gauge reaches the empty level.
STORAGE Bridge
NE TODI
V1.00
14:30:29 10-JAN-2013
MCopy Ready
780 GB
HDD 0
780 GB
HDD 1
Log File
Setup
14:30:29 10-JAN-2013
Power Off
Reference
●
The NSB-25 can be off via the power key by pressing for more than 7 seconds
when frozen
