Nexta Tech SCREEN-ML/One, Инструкция по эксплуатации

Страница: 15 / 24

6.4 SETTING THE DEVICES CONNECTED TO THE WIRED INPUTS
Default:
Input1= Wind sensor
Input2= Rain sensor
Input3= Sun sensor
This procedure changes the type of device connected to the wired inputs. The device can be a sensor or a button
dedicated to controlling the movement of the motors or control the lights.
ATTENTION:
- By wire, the light can be controlled in a synchronized way
- The same type of sensor cannot be set only on one input. Example: I cannot set the wind sensor on input 1 and on input
2.
STEP 1
Make a long press of keys 1 and 2.
The led lights up green.
INPUT 1
INPUT 1
INPUT 2
INPUT 2
ACTION: long press button 1 and 2 LED: turn on green
STEP 3A
Make a short press of button 1, the LED
starts Flashing
STEP 4A
To end the count press the button 1 for a
short time during the Flash that corresponds
to the function desired
FLASH FUNCTION
1 Wind sensor
2 Rain sensor
3 Sun sensor
4 Motor: Step by step button
5 Motor: Open button
6 Motor: Close button
7 Motor: Open button (Dead man)
8 Motor: Close button (Dead man)
9 Motor: Open/Close button (Dead
man)
10 Lights: On/Off (short press) and
dimmer (long press) button
STEP 4B
To end the count press the button 2 for a
short time during the Flash that corresponds
to the function desired
FLASH FUNCTION
1 Wind sensor
2 Rain sensor
3 Sun sensor
4 Motor: Step by step button
5 Motor: Open button
6 Motor: Close button
7 Motor: Open button (Dead man)
8 Motor: Close button (Dead man)
9 Motor: Open/Close button (Dead
man)
10 Lights: On/Off (short press) and
dimmer (long press) button
STEP 3B
Make a short press of button 2, the LED
starts Flashing
15