Operator’s Manual for the Bullet Blender
®
5
sample tube plate with an 1/8” hex
wrench, wipe out the spill using
standard
laboratory
safety
precautions, and replace the sample
tube plate. Do not touch or tamper
with the electronics.
TROUBLESHOOTING
Provided below is a list of
troubleshooting tips. Additional tips
can be found in the User Guide.
If the Bullet Blender doesn’t
start,
make sure the power switch is
in the ON (I) position. Make sure that
the sample plate lid is in the “locked”
position. The plug of the power supply
cord might not be in a live wall outlet
or the power supply connector might
not be fully inserted in the AC Input
Receptacle of the Bullet Blender50-
DX.
If the unit stops working,
turn
the system off for 15 minutes to allow
the electronics to reset. If the Bullet
Blender 50-DX does not turn on after
this period, contact customer service.
If the caps on the 50 mL tubes
loosen,
make sure that the screw
threads between the lids and the caps
are dry when you close the caps or
screw them on, so that there is enough
friction for the caps to remain tight.
Using recommended types of tubes
will minimize cap failure.
For best results, the tubes and
sleeves should be evenly spaced when
placed in the Bullet Blender.
SUPPORT
FAQs, protocols, and other
helpful information are available on
our website,
For additional assistance, please
contact customer service by email at
[email protected]
by telephone at (518)674-3510 or
(800)738-1681.
SPECIFICATIONS
Size:
35 cm (14 in.) deep x 38 cm (15
in.) wide x 38 cm (15 in.) high.
Weight:
33lbs (15 kg)
Power Requirement:
100-240 V, 50-
60Hz, 2.5-4.5 A
Capacity:
8 of 50 mL skirted (self-
standing) TPP
®
polypropylene tubes.
Relative Humidity:
5 - 90%
non- condensing
Operating Temperature:
4 - 40°C
Altitude: <2000m
Storage Temperature:
-40 to 50°C
-CE models meet
requirements.
WARRANTY
Next Advance warranties its
products against defects in materials
and workmanship for time periods
which vary according to the product.
Within these time periods, Next
Advance will replace or repair,
without
charge
to
the
original
purchaser, any part which is defective.
The Bullet Blender warranty is two
