6. Quick test
In order to test if the XZ Light sensor is installed correctly, please follow the test procedure below:
© 2021 Nexmosphere. All rights reserved. v1.0 / 08-21
All content contained herein is subject to change without prior notice
N ex m o s p h e re
Le H av re 1 3 6
5 6 2 7 SW E i n d h ove n • T h e N e t h e r l a n d s
T
+ 3 1 4 0 2 4 0 7 0 7 0
E
s u p p o r t @ n ex m o s p h e re.c o m
PRODUCT MANUAL | XZ LIGHT SENSOR
7
Step 1 - Setup
First, connect the Light sensor to an Xperience
controller. Secondly, power the Xperience controller.
The green status LED of the XZ Light sensor should go
on. The status LED of the controller will start to blink
and once power-up is completed will be lit continuously.
Step 2 - Pick-up and place-back detection
Cover the light sensor to trigger a place-back. If the
sensor is not yet installed behind a front panel, you
can for example place the sensor with the bottom
(flat) side on a table.
Both the green status LED of the sensor and the status
LED of the controller should blink.
Uncover the light sensor to trigger a pick-up. If the
sensor is not yet installed behind a front panel, you
can rotate the sensor so that the bottom (flat) side is
facing upwards and towards the light.
Both the green status LED of the sensor and the status
LED of the controller should blink.
For a full test we recommend to connect the setup to
a mediaplayer or PC and test all API commands listed
in this document (see section 3, page 2). For more
information on how to setup a test for your controller,
please see the Quick Start Guide of the Xperience
controller you are using. These are available on
nexmosphere.com/support-documentation
Please contact
for any
support questions you may have.
In case any of the steps above does not provide
the expected result, please check the installation
guidelines in this document.
XN
Connect to powered
USB port
XN
Connect to powered
USB port
LED BLINK
LED BLINK
XN
Connect to powered
USB port
LED BLINK
LED BLINK
