6. Quick test
In order to test if the X-Eye Gender sensor is installed correctly, please follow the test procedure below:
© 2020 Nexmosphere. All rights reserved. v1.0 / 11-20
All content contained herein is subject to change without prior notice
N ex m o s p h e re
Le H av re 1 3 6
5 6 2 7 SW E i n d h ove n • T h e N e t h e r l a n d s
T
+ 3 1 4 0 2 4 0 7 0 7 0
E
s u p p o r t @ n ex m o s p h e re.c o m
PRODUCT MANUAL | X-EYE GENDER SENSOR
8
Step 1 - Setup
First, connect the X-Eye Gender sensor to an
Xperience controller. Secondly, power the Xperience
controller.
The green status LED of the X-Eye Gender sensor
should go on. The status LED of the controller will
start to blink and once power-up is completed will be
lit continuously
Step 2 - Test detection
Stand in front of the sensor with you face directed
towards the sensor's lens.
The status LED of the controller should blink.
For a full test we recommend to connect the setup to
a mediaplayer or PC and test all API commands listed
in this document (see section 3, page 2-3). For more
information on how to setup a test for your controller,
please see the Quick Start Guide of the Xperience
controller you are using. These are available on
nexmosphere.com/support-documentation
Please contact
for any
support questions you may have.
In case any of the 2 steps above do not provide
the expected result, please check the installation
guidelines in this document.
XN
this side up
X-Eye
Connect to powered
USB port
XN
this side up
X-Eye
LED BLINK
