Copyright © 2019 NEXCOM International Co., Ltd. All Rights Reserved.
49
NViS 6308 Series User Manual
Chapter 4: BIOS Setup
Firmware Update Configuration
Me FW Image Re-Flash
Enables or disables the ME firmware image re-flash function.
Advanced
Version 2.18.1263. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable/Disable Me FW Image
Re-Flash function.
Me FW Image Re-Flash
[Disabled]
SIO Configuration
This section is used to configure the serial ports.
[*Active*] Serial Port 1 to [*Active*] Serial Port 6
Enters the submenu of [*Active*] Serial Port 1 to [*Active*] Serial Port 6.
Advanced
Version 2.18.1263. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
View and Set Basic properties
of the SIO Logical device.
Like IO Base, IRQ Range, DMA
Channel and Device Mode.
AMI SIO Driver Version: A5.09.01
Super IO Chip Logical Device(s) Configuration
[*Active*]
Serial Port 1
[*Active*]
Serial Port 2
[*Active*]
Serial Port 3
[*Active*]
Serial Port 4
[*Active*]
Serial Port 5
[*Active*]
Serial Port 6
WARNING: Logical Devices state on the left side of the
control, reflects the current Logical Device state. Changes
made during Setup Session will be shown after you restart
the system.
