Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
6
NCr-301-VHR User Manual
Chapter 1: Product Introduction
Hardware Installation
1. Position the placement sticker at the
desired installation location and use
a driller to drill the three holes on the
sticker.
2. Insert three screw anchors into the
holes then place the wall mount base
on top of them with the mounting
holes aligned.
3. Open the camera’s cover and glue the
dehumidifier packet onto the metal
bracket using the adhesive sticker on
its back, as depicted in the diagram
below. Close the camera’s cover and
ensure the clip is locked in position.
Install the sunshield and tighten a torx
screw on the side of the cover.
Lock
4. Secure the connecting bracket
to the camera’s rear.
5. Press and hold down the latch
on the wall mount bracket
and put it into the connecting
bracket. Once in place, secure
the other side using the supplied
hex wrench.
Press
6. Align the mounting holes on
the wall mount bracket to the
mounting holes on wall mount
plate, then secure it tightly with
screws to finish the installation.
