Newworld NWINT15FSW, Инструкция по эксплуатации

Страница: 16 / 41

Installing your Dishwasher
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
WARNING: Use the new water inlet hose
supplied with your machine, do not use an old
machine’s hose.
WARNING: Run water through the new hose
before connecting.
WARNING: Connect the hose directly to the
water inlet tap. The pressure supplied by the tap
should be a minimum of 0.03 MPa and a maximum of
1 MPa. If the pressure exceeds 1 MPa, a pressure relief
valve must be fitted between the connection.
WARNING: After the connections are made,
turn the tap on fully and check for water leaks. Always
turn off the water inlet tap after a wash program has
finished.
Installing your Dishwasher
Bringing it all together
3.1 Positioning your Machine
When positioning the machine, place it in an area
where dishes can be easily loaded and unloaded. Do
not put the machine in an area where the ambient
temperature falls below 0°C.
Read all warnings located on the packaging before
removing the packaging and positioning the machine.
Place the machine close to a water tap and drain. Take
into consideration that the connections will not be
altered once the machine is in position.
Do not hold the machine by its door or panel.
Leave an adequate distance around the machine to
allow ease of movement when cleaning.
Ensure the water inlet and outlet hoses are not
squeezed or trapped and that the machine does not
stand on the electrical cable while positioning.
Adjust the feet so the machine is level and balanced.
The machine should be placed on flat ground
otherwise it will be unstable and the door of the
machine will not close properly.
3.2 Water Connection
We recommend fitting a filter to your water inlet supply
in order to prevent damage to your machine due to
contamination (sand, rust, etc.) from indoor plumbing.
This will also help prevent yellowing and deposit
formation after washing.
3.3 Water inlet hose
An Aquastop water spout is available with
some models. Do not damage it or allow it to
become kinked or twisted.