Newworld NWG60B, Инструкция по эксплуатации

Страница: 14 / 30

Installing your Built-in Gas Hob
Bringing it all together
Installing your Built-in Gas Hob
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Fixing the seal to the back of the hob
The hob must be sealed to the work surface to
prevent liquid from entering into the cabinet. A tape
seal is supplied with the hob. Refer to Fig. 3.4.
1.
Turn the hob over and place in on a secure, level surface.
Spread the longer seal “A” around the inner left, rear and right sides.
,
3.
With a cutter or scissors cut the excess seal and retain for
next use.
Spread the seal “B” around the left, front and right outer edges of the
cooktop.
5.
Fastening the Installation Bracketss
Each cooktop is provided with an installation kit
including brackets and screws for fastening the
top to fixture panels from 20 to 40 mm thick.
Refer to Fig. 3.4.
1. Turn the cooktop upside down and fasten the
brackets “F” and “R” to the appropriate socket
holes, without tightening the screws for the
moment.
Make sure that the brackets are fastened.
Installing the Hob
2.
4.
Spread the seal “C” along the rear edge of the cooktop.
Making sure that the beginning and the end overlap at
the seal “B”.
2.
1. Turn the hob back the right way up and
position it in the worktop cut-out.
2. Insert the cooktop into the hole and position it correctly.
3. Adjust the position of the brackets “F” and “R”
and tighten the “Rear Screw” and “Front Screw”
to lock the cooktop firmly in position (Fig. 3.5).
4. With a sharp cutter or trimmer knife trim the
excess sealing material around the edge of the
cooktop. Take care not to damage the
workbench.
If the surface that the hob is to be fitted is tiled,
or is not reasonably smooth, additional sealing
with a waterproof silicone sealant may be
required.