Newworld NWG60B, Инструкция по эксплуатации

Страница: 10 / 30

Getting to know your Built-in Gas Hob 10
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Placement of Burner Heads and Caps
For all burners:
•
Place a burner cap on each burner head (see
Figur.
1
), matching the cap size to the head
size. The cap for each burner has an inner
locating ring which centers the cap correctly
on the burner head. Be sure that all the burner
caps and burner heads are correctly placed
BEFORE using your appliance.
•
Make sure each burner cap is properly
aligned and level (see Figure.
2
).
•
Turn the burner on to determine if it will
light. If the burner does not light, contact
a qualified service center. Do not service the
sealed burner yourself.
Figure 1
Figure 2
Surface Cooking Utensils
For lower gas consumption and better efficiency: Use only flat-bottomed pans of dimensions
suitable for the burners, as shown in the table below. Check for flatness by rotating a ruler across the
bottom of the pan. There should be no gaps between the pan and ruler. As soon as a liquid comes
to a boil take care to turn the flame down to a level that will just keep it simmering.
Specialty pans (lobster pots and pressure cookers) may be used but must conform to the recommended
cookware requirements.
Getting to know your Built in Gas Hob
You’ll be up and running in no time