NTSecureGateway
7 / 14
User Manual
11648_0008_0012_UM-User_Manual
Revision: DV A1
NewTec GmbH · Buchenweg 3 · 89284 Pfaffenhofen a.d. Roth · Germany · Tel.: +49 7302 9611-0 · [email protected] · www.newtec.de
F9
05
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Safety Instructions
This description is part of the device. It contains texts and illustrations for the correct handling of the module
and must be read before installation or use.
Please follow the instructions in the description. Non-observance of the instructions, operation outside the
intended use, incorrect installation or incorrect handling can result in serious impairments to the safety of
people and systems.
The device may only be installed, connected, put into operation, changed or retrofitted by a qualified
electrician.
Disconnect the device from the external power supply before carrying out any work on it. In the event of
installation and system faults, the mains potential may be connected to the control circuit for devices that are
not electrically isolated. If necessary, also switch off independently supplied output load circuits.
For the installation of the device, the safety regulations of the electrical engineering and the employers' liability
insurance association must be observed.
Only the signals indicated in the technical documentation may be applied, and only components from the
approved accessory components list of NewTec GmbH may be connected to the device’s connection
terminals.
In case of malfunctions or ambiguities, please contact the manufacturer. Tampering with the device might
seriously impair the safety of people and equipment. They are not permitted and will lead to exclusion of liability
and warranty.
The proper and safe operation of the products requires proper transport, proper storage, set-up, assembly,
installation, commissioning, operation and maintenance.
Any manipulation will void the warranty.
