RollMaster™ 1000
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St. Unit F, Aurora, CO 80011
T
800.624.6706
F
303.364.7796
•
Newstripe.com
RollMaster™ 1000 Manual / 3856.0917
CLEANING PROCEDURE
1.
When you are finished striping, open the Trough and roll forward on a dry painted line or cardboard to transfer
excess paint from the Roller Cover.
2.
Remove the end of the Paint Hose attached to the Paint Can Tube. Keep the hose upright to avoid dripping
paint.
3.
Squeeze the Paint hose through the side of the Eye Bolt and remove Paint Hose, Mandrel tube, and Mandrel
with Roller Cover from the machine.
NOTE: This prevents any paint coming into contact with the pumping mechanism.
4.
Set the Mandrel Tube and Paint Can Tube aside for cleaning.
5.
Remove one Knurled Nut and Regulating Disc from Mandrel and slide Roller Cover off. Remove second Knurled
Nut and Regulating Disc from Mandrel. Discard Roller Cover, Regulating Discs, and Paint Hose.
6.
Clean Mandrel, Knurled Nuts, Mandrel Tube, and Paint Can Tube with *water or solvent for further use.
*DO NOT THROW AWAY THE MANDREL, KNURLED NUTS, PAINT CAN TUBE, OR MANDREL TUBE AS THESE ARE
PERMANENT PARTS OF THE MACHINE.
NOTE: Always use the solvent recommended by the paint manufacturer. DO NOT use petroleum base cleaners
or thinners with water based paint. The cleaner will react with the paint, making it difficult to clean.
7.
Apply a light coat of oil to all moving parts. (3 in 1 or light spray oil)
TROUBLESHOOTING GUIDE
PROBLEM
REMEDY
Paint not getting to roller or too little
paint getting to roller.
1.
Make sure trough is closed.
2.
Check paint hose for kink. If hose is kinked open Trough and rotate
hose.
3.
Check Pump Drive Wheel is contacting Rear Wheel. If not adjust the
cable at the frame.
4.
Check that all Pump Rollers are rotating. If not clean rollers of debris or
paint and lubricate.
5.
Check to see if your paint is “Set Fast” or “Fast Dry”. These paints are
not recommended and require thinning, which may cause the paint
to dry slower, or can diminish overall line quality.
Painted line is solid on one side, but
“light” or skipping on the other side.
1.
Check that the Roller Cover slides up and down freely in the “J” Yoke
and that the Mandrel is not binding. Adjust the “J” Yokes if needed or
clean debris and paint off “J” Yokes.
2.
If the Mandrel and Roller Cover is “riding up” on the Mandrel Carrier
sides, grease the Mandrel Tube end and “O” ring with light oil.
Painted line has heavy ridges on edges
or excessive paint.
1.
Make sure you are using the proper Regulating Discs.
2.
Periodically release Control Lever every couple of feet during striping
to avoid the Roller Cover from becoming oversaturated.
Paint line skips across width of roller.
1.
Make sure the Mandrel and Roller Cover are rolling freely. If not,
grease “O” ring end of Mandrel Tube and “O” ring.
Your machine is designed to be simple and safe to operate.
If you have any questions during setup, painting or cleaning, please call us! 1-800-624-6706
Page 5 of 8
Содержание RollMaster 1000
Страница 10: ......
