Newstripe RollMaster 1000, Руководство по эксплуатации продукта

Страница: 4 / 11

RollMaster™ 1000
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St. Unit F, Aurora, CO 80011 T 800.624.6706 F 303.364.7796 • Newstripe.com
RollMaster™ 1000 Manual / 3856.0917
Assembly
1.
Remove the chassis and handle assembly from the box (Pic 2).
2.
Rotate the folding handle upright so that the holes are aligned with the corresponding holes in the chassis. Be
careful not to damage the control cable (Pic3).
3.
Fasten the Handle to the chassis with the provided Wing Nuts to the outside of the Handle (Pic3).
4.
Rotate the top section of the Handle upward to the unfolded position and then tighten the Wing Knobs.
5.
Pull up on the Cable Adjuster with Cable and slip into slot in the chassis. (Pic 4)
Note: The Cable Adjuster should be positioned all the way into the slot with the hex nut above the plate and round
adjusting nut below the plate.
6.
Adjust the nuts on the Cable Adjuster for proper operation. When adjusted correctly, the Pump Rollers will spin
when the Control Lever is squeezed and stop spinning when the Control Lever is released.
7.
The Guide bar / Kickstand raises the Mandrel off the surface when it is in the vertical position. When lowered for
striping it can also serve as a line guide (Pic 2).
8.
Remove the protective film from the Regulating Discs before installing (Pic 5).
9.
Place one Regulating Disc on one end of the Mandrel core (threaded area) and screw on one Knurled Nut (finger
tight). Slide the Roller Cover onto the Mandrel and install the second Regulating Disc and Knurled Nut. Tighten the
nuts fully by hand.
NOTE: PVC spacers will be included with your kit if you ordered 2" or 3" wide rollers. Follow the above assembly
instructions, except you must add these spacers between the plastic disc and the knurled nut.
3
2
Your RollMaster™ 1000 box should
include these parts:

Can hole punch

Paint can tube

Mandrel w/ Knurled nuts

Mandrel tube with “O” ring

4” Roller kit (3 pk.)

Handle hardware
4” Roller Kit
Guide bar/
Kickstand (31)
((()
33((31)extension
bracket
Wing
nut (33)
Quick release
pin (32)
Cable adjuster (29)
in correct position
Pic 2
Regulating disc
Cable adjuster
in correct position
Wing
Nut (33)
Wing nut
Pic 3
Pic 4 Pic 5
Mandrel w/
Knurled nuts
Paint can tube
Can hole punch
Mandrel tube
Handle hardware
Guide bar/
Kickstand
Page 2 of 8