FieldLiner 3™
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St. Unit F, Aurora, CO 80011
T
800.624.6706
F
303.364.7796
•
Newstripe.com
FieldLiner 3™ Manual / 4867.0917
CLEANING PROCEDURES
CLEAN AFTER EVERY USE!
1.
When your painting job is complete, empty the tank of unused paint. To do this, relieve the tank pressure by turning
the knob 1/4 turn counter-clockwise on the pressure relief valve.
2.
Disconnect the paint hose at the spray gun and place the open end in a container you wish to save the paint in.
Pressurize the tank to 2-3 psi and the paint will be pumped from tank into the container. After the paint has been
drained, reconnect the hose to the spray gun.
3.
Pour 1-2 gallons of water into the tank and swab the inside with a rag. Re-pressurize the tank and force the liquid
through the system by pulling the control lever. Repeat the above procedure until no residue of paint is shown in
the liquid. Operate the spray nozzle until the gun is cleared of all paint.
4.
Remove the nozzle cap and nozzle from the spray gun and clean them thoroughly.
5.
Clean and rinse the exterior of the machine. Pressure washing is not recommended. Use soapy water (dishwashing
detergent or Simple Green) once each week.
MAINTENANCE
ITEM
CHECK
MAINTENANCE ACTION
Paint Tank and Lid Gasket
After every use
Clean the paint tank and lubricate
the lid gasket
Hoses and Nozzle
After every use
Clean and replace as needed. Run
soapy water through the system for
additional cleaning
Handles
Monthly
Check handles for tightness to frame
**For additional instructions please contact Newstripe, Inc. at 800-624-6706
Page 5 of 8
