ECOLINER™
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St., Unit F, Aurora, CO 80011
T
800.624.6706
F
303.364.7796
•
Newstripe.com
EcoLiner™ Manual / 4483.0917
OPERATION
1
.
Always pre-lubricate the sprayer with water
prior to operation
.
Fill the pail ½ full with water
and secure the lid, making sure the suction hose
with filter screen is at the bottom of the pail. It
is advisable to familiarize yourself with the
equipment operation by using water the first
time.
2. Turn on the pump with spray rocker switch on
the handle. Allow 15-30 seconds for the pump
to prime.
3. The unit is shipped with the nozzle for a 4” wide
line installed. Note: The height of the spray
nozzle will increase or decrease the line width.
Raise or lower as needed
4. Unsnap the pail lid and pour properly thinned
paint into the pail.
NOTE: These paints are typically thinned at a
minimum ratio of 1:1. Follow suggested paint
thinning guidelines per the paint manufacturer’s
instructions.
5. Press the forward part of the spray rocker
switch to the on position. Allow 15-30 seconds
for the pump to prime. Check for leaks and
tighten any fittings as required.
NOTE: Back position is momentary on, center is
off, forward position is continuous operation.
6. Position the spray nozzle and shields where the
painted line is to begin, and engage the spray
rocker switch to desired position. An even flow
of paint should spray from the nozzle.
7. Put spray rocker switch into center position,
when you would like to machine to stop
spraying.
OPERATIONAL NOTE!
NOTE: If the pump does not run, check the fuse in the blue fuse
holder. Check first to make sure the fuse is pushed in all the way. If
this is not the problem, replace the fuse. If the unit will still not run,
and both power supply cables are attached correctly to a fully
charged battery, contact Customer Service at 1-800-624-6706.
