ECOLINER™
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St., Unit F, Aurora, CO 80011
T
800.624.6706
F
303.364.7796
•
Newstripe.com
EcoLiner™ Manual / 4483.0917
CLEANING PROCEDURES
CLEAN AFTER EVERY USE
1.
When your striping job is complete, remove the pail
lid and set aside. Pull out the suction hose and
place it in a clean water container. Empty pail of
unused paint, or remove pail completely and cover
for use the next time you stripe. Place another
empty pail on machine.
2.
Wipe off or rinse off pick up tube, screen on pick up
tube, and pail lid.
3.
Remove nozzle cap, nozzle, and nozzle screen and
put in container of water to soak.
4.
Place 2 gallons of clean water in the pail. Place the
suction hose back in pail. Turn on the spray rocker
switch and spray through nozzle.
5.
Turn on the spray rocker switch to “spray” position
and flush clean water through nozzle.
6.
Operate spray nozzle until the gun is cleared of all
paint.
7.
Clean nozzle parts that have been soaking and
reassemble on spray valve.
8.
Clean and rinse exterior of machine. Pressure
washing is not recommended. Use soapy water
(dishwashing detergent or Simple Green) once each
week.
NOTE: Always leave some of the cleaning solution
or Newstripe’s pump protector in the pump when
not in use. This keeps the internal pump
components lubricated. DO NOT run the pump
without liquid. If you need to store the unit for
extended periods or in freezing areas, run water
and dishwashing detergent through the pump to
clean out all paint and replace with Newstripe’s
pump protector. For further protection, order
Newstripe pump protector to use during storage.
MAINTENANCE
ITEM
CHECK
MAINTENANCE ACTION
Paint Pail/Tank
After every use
Clean paint pail/tank, hoses and
nozzle
Hoses and Pump
After every use
Run soapy water through pump for
additional cleaning
Handles
Monthly
Check handles for tightness to frame
**For additional instructions please contact Newstripe, Inc at 800-624-6706
