Newstripe 4600 SP Airless, Руководство по эксплуатации продукта

Страница: 8 / 13

4600™ Self-Propelled Airless Sprayer
ALWAYS wear safety goggles or protective eye-wear when operating the unit !
4600™ SP Manual / 3031.0517
Page 5 of 9
CLEANING PROCEDURE FOR EXTENDED PERIODS OF NON-USE
1. Clean as instructed in cleaning procedure.
2. Pick up suction filter and hold with bottom facing up.
3. Pour 2 ounces of pump protector into suction filter so there is approximately 2 inches of fluid showing in inlet
hose.
4. Leave engine off and pull recoil start until you see fluid in return hose.
5. Unit may now be stored with fluid remaining inside hose and pump
CLEANING PROCEDURE FOR WINTER (FREEZING) STORAGE
1. Clean as instructed in cleaning procedure and then place ½ bottle of pump protector in pail.
2. Place spray knob in prime position and run pump until pump protector is seen flowing from return hose.
3. Turn spray knob to spray position and trigger gun until pump protector sprays from gun.
4. Turn spray control knob to prime position, turn off pump and trigger spray gun to release pressure.
5. Move pump engaging lever to “OFF” position.
6. Remove as much fuel from the engine gas tank as you can.
7. Run engine until it runs out of gas.
8. Disconnect paint hose from pump and gun then, drain hose.
9. Unit may now be stored in freezing temperatures.
10. Drain and change engine oil in the spring.
MAINTENANCE
ITEM CHECK MAINTENANCE ACTION
Engine Oil Before each use Change oil after first 20 hours of operation and
then, every 100 hours
Spark Plug & Air Filter Every 4 Months Clean or change as needed
Wheels Lubricate weekly Grease with high quality axle lubricant
Drive Operating and Pump engaging
Levers Lubricate weekly Oil pivot points with light machine oil
Spray Gun Clamp and Cable Check Weekly Spray with silicone spray
Spray Gun Filter Check Monthly Replace if filter becomes clogged
Spray Pump Before and after each use Use pump protector if the unit will not be used
for more than one day
Suction Filter Before each use Replace as needed or when clogged
Suction Tube Before each use Replace if needed or has cuts
Bypass (re-circ) hose Before each use Replace if needed or has cuts
Spray Hoses Before each use Replace if needed or has cuts
Spray Tip Before each use Replace if spray pattern is uneven
Outlet Push Button Before each use Replace every 1000-1500 gallons or if leaking
Outlet Valve If pump does not prime Replace every 500-1000 gallons
Inlet Valve If pump does not prime Every 500-1000 gallons
Prime/Spray Valve If pump will not toggle
between Prime/Spray Every 1000-1500 or if it stops working