Newstripe 4600 SP Airless, Руководство по эксплуатации продукта

Страница: 5 / 13

4600™ Self-Propelled Airless Sprayer
ALWAYS wear safety goggles or protective eye-wear when operating the unit !
4600™ SP Manual / 3031.0517
Page 2 of 9
ASSEMBLY
1. Remove the unit from the crate and open
packing cartons. Check for any damage that
may have occurred during shipment.
Advise factory immediately if you see any
damage.
2. Unpack spray gun support tube, spray gun
mounting bracket and spray shields.
3. Slide one spray shield onto gun support
tube from each end. (Longer part faces
upright). Snug star knobs. (Pic 1)
4. Slide tube with shields into receiving tube
on front of machine and snug star knobs.
(Pic 1)
5. Slide the spray gun mounting bracket onto
the upright and hand tighten star knob. (Pic
1)
6. Place the spray gun (without the hose
attached) in the holder and secure with the
clamp. (Pic 1)
7. Check placement of spray gun in gun
holder. Spray gun should be far enough
forward so that there is room between the
trigger and lifting bar attached to the plate
(1/8”-3/16”). This will allow the gun to shut
off completely when the trigger is released.
(Pic 1)
8. There should also be enough room to push
the trigger lock sideways. If the trigger lock
will not push, release the gun clamp and
slide gun backward until you can push the
trigger lock. Re-clamp gun. NOTE to release
trigger lock: Push the trigger lock in on the
right side (outside) of the gun. (Pic 1)
9. Attach one end of the spray hose to the
pump outlet with a ¾” wrench and the
other end to the spray gun. You will need
two wrenches (3/4” and 9/16” or two
adjustable wrenches) to secure the hose on
the spray gun as it has a swivel fitting.
Make both connections tight. (Pic 2)
10. Always check the oil level in the engine
before starting (SAE 10W30).
11. Make sure that the static chain is
contacting the ground
(Attached to the
bottom side of the frame).
12. If unit was shipped with suction hose
removed at the pump. (Garden hose type
fitting). Depress Inlet Valve Stem to ensure
it moves freely. Attach suction hose. Hose
fitting may be hand tightened. You may
also need to perform this operation any
time the pump does not want to prime. (Pic
2)
Pic 1
Pic2
Pic 3
Receiving
tube
Spray gun
support
tube
Spray
Shields
Star knob