Newport CONEX-NSA12, Руководство пользователя для графического интерфейса

Страница: 7 / 28

CONEX-PP Controller GUI Manual
1.0 Introduction
1.1 Purpose
The purpose of this document is to provide instructions on how to use the CONEX-PP
controller series GUI.
1.2 Overview
The CONEX-PP series GUI is a graphical user interface (GUI) which allows the user to
interact with the controller that is integrated with intelligent stepper motor stages. The
user can initiate moves, change the state of the controller, adjust configuration
parameters, etc. Communication with the Intelligent Stepper Motor Stages is achieved
via an RS-422 serial link and a USB to RS422 adaptor. The provided GUI requires USB
communication interface, based on Windows TM operating system. Advanced
programming is simplified by an ASCII command interface and a set of two letter
mnemonic commands.
1.3 Controller Specifications
Description Single-axis motion controller and driver for Intelligent stepper motors
Control capability Stepper motors, open loop
Motor Output Power 24 VDC peak, 2.5 A peak PWM amplifier
Control Loop - PI control of motor phase current with programmable idle state
- 2kHz servo rate
- Backlash compensation
Motion Point-to-point motion with S-gamma profile and jerk time control
Computer Interface USB +5V (USB): <0.5 A, Windows Compatible
Programming - Natural user defined units
- 40+ intuitive, 2-letter ASCII commands
- Command set includes: software limits, user units, synchronized motion start, stop all, ...
Communication rate 115,200 baud (serial link over USB)
Safety Feature - End of range checks
- Power limit checks
- Watchdog timer
Power Requirements +24 V (FC-PS40): <1.67 A
Controller Dimensions 4.33" x 2.06" x 0.98" (110 x 52.2 x 25 mm)
Cable Length [ft. (m)] 9.8 (3)
Single-Axis Intelligent Stepper
Motor Controller/Driver
CONEX-PP
1 EDH0350En1031 – 12/18