Newport CONEX-NSA12, Руководство пользователя для графического интерфейса

Страница: 17 / 28

CONEX-PP Controller GUI Manual
“Cyclic Motion” and “Target position / PA”
In the “Cyclic Motion” area, a motion cycle is configured with a number of cycles
(Cycle) and a dwell time in milliseconds. The motion cycle gets the defined target
positions from the “Target Motion / PA” area to perform the cycle.
In the “Target Motion / PA”” area, two target positions can be defined. The “Go to”
button executes the absolute move to go to the specified target position.
“Motion Configuration Values”
In the “Motion Configuration Values”, the current ends of run, velocity, and
acceleration are displayed in this area: “Minimum end of run”, “Maximum end of run”,
“Acceleration”, and “Velocity” can be modified and saved with the “Set” button.
Memorized positions
The combo box memorizes the positions set by the “Save Pos.” button. Each of these
positions can be renamed or deleted. To execute an absolute move to one of these
memorized positions, select one item of the combo box and click on the “Go to” button.
When the mouse moves over to the combo box, the position is shown in an information
balloon.
Rename a memorized position: Select an item from the combo box, edit the position
name to change it and click on the “Rename” button to save the new position name.
Delete a memorized position:
Select an item from the combo box, right-click on the
mouse and select the “Delete” menu to delete the selected memorized position.
NOTE
The CONEX-PP controller supports native units of millimeter (NSA) or degrees
(NSR). All the parameters such as position, velocity and acceleration are defined
on the same scale. These units are not shown in the GUI.
• Position (Units)
• Velocity (Units/s)
• Acceleration (Units/s 2 )
Loop #1
Loop #2
Tempo (Dwell)
Target #2
Target #1
Tempo (Dwell)
Tempo (Dwell)
Tempo (Dwell) Loop #N
11 EDH0350En1031 – 12/18