Newport Electronics i Series, Руководство оператора

Страница: 19 / 56

3.2.2 Set Points Menu
SETPOINT 1:
Press
a
1) Press
a
, if necessary until
SP1
prompt appears.
Press
d
2) Display shows previous value of “Setpoint 1” with 1 st digit
flashing.
Press
b
&
c
3) Press
b
and
c
to increase or decrease Setpoint 1
respectively.
Holding
b
&
c
buttons down for approximately 3 seconds will speed up the
rate at which the set point value increments or decrements.
Press
b
&
c
4) Continue to use
b
and
c
to enter your 4-digit Setpoint 1 value.
Press
d
5) Display shows
STRD
stored message momentarily and then
advance to SP2 only, if a change was made, otherwise press
a
to advance to
SP2
Setpoint 2 Menu.
SETPOINT 2:
Press
d
6) Display shows previous value of “Setpoint 2” with 1 st digit
flashing.
Press
b
&
c
7) Press
b
and
c
to increase or decrease Setpoint 2
respectively.
Holding
b
&
c
buttons down for approximately 3 seconds will speed up
the rate at which the setpoint value increments or decrements.
Press
d
8) Display shows
STRD
stored message momentarily and then
advances to CNFG only, if a change was made, otherwise press
a
to advance to
CNFG
Configuration Menu.
15