Configuring Advanced Settings
NA-1400
43
When the checkbox is checked, the NA-1400 will enable logging at each boot.
When the checkbox is blank, the NA-1400 will disable logging at each boot.
Note:
If you believe that sending configuration files via e-mail might compromise your
security, read the text below to determine what pieces of information are included
and how information is encrypted, then make a decision.
The configuration snapshot contains:
•
Network configuration (host and domain names, gateway, gateway device, and IP addresses of the
NA-1400.
•
Information about NA-1400 shares.
•
Status and debug log files of management engine and Samba service.
•
Kernel modules configuration file.
•
A list of hardware devices present in the system, and their specific features.
Notes:
The configuration snapshot is a compressed file that is encrypted with the PGP
key. It means that only an owner of the key can decrypt the data retrieved from
your NA-1400. It can be the NA-1400 or server-side software vendor.
No passwords are included into the snapshot, except for the proxy and Web
repository credentials that might be used at NA-1400 update time.
Use logging only for troubleshooting and disable this option at regular operation
time in order to avoid server operation slowdowns and waste of a disk space on
system partitions.
Make Backup Copies of System Files
It is possible to make backup copies of system files. This can be useful for recovery procedures.
To make backup copies of system files:
1.
Have a USB hard drive or flash drive on hand that contains a valid FAT partition with
at least 256
megabytes
of free space. Such a drive can be partitioned and formatted under Windows.
2.
Connect the USB drive to any USB port at the rear of the NA-1400.
3.
Log on using the Web interface.
4.
Click
Maintenance
in the main menu.
5.
Click the
Backup
tab.
6.
Pick the desired flash or hard drive from the list of available USB drives. Refresh the page in a few
seconds if no drives display on the list.
7.
click the
Backup
button to begin the process. The backup of the system files begins.
8.
In about five to ten minutes, the process is over. The success message displays.
You can disconnect the USB drive from the NA-1400.
Содержание NA-1400
