16. Never install telephone wiring during a lightning storm.
17. Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
18. Never touch uninsulated telephone wires or terminals unless the telephone line
has been disconnected at the network interface.
19. Use caution when installing or modifying telephone lines.
Battery Safety
CAUTION:
Danger of explosion if the BATTERY PACK is incorrectly replaced. Replace only with the
same or equivalent type. To reduce the risk of fire personal injury, read and follow these
instructions:
1. Use only the following type and size of BATTERY PACK:
Cordless Telephone BATTERY PACK
3.6V, 550mAh
Ni-Mh AAA
2. Do not dispose of the BATTERY PACK in a fire. It may explode. Check with local codes for
possible special disposal instructions.
3. Do not open or mutilate the BATTERY PACK. Released electrolyte from a BATTERY PACK is
corrosive and may cause damage to the eyes or skin. Electrolyte may be toxic if swallowed.
4. Exercise care in handling the BATTERY PACK to prevent shorting the BATTERY PACK with
conductive materials such as rings, bracelets and keys. The BATTERY PACK or conductor may
overheat and cause burns.
5. Charge the BATTERY PACK provided with (or identified for use with) this telephone only in
accordance with the instructions and limitations specified in this manual.
6. Observe proper polarity orientation between the BATTERY PACK and BATTERY CHARGER.
SAVE THESE INSTRUCTIONS
ATTENTION:
The telephone that you have purchased contains a rechargeable BATTERY PACK. The BATTERY
PACK is recyclable. At the end of its useful life, under various state and local laws, it may be illegal
to dispose of this BATTERY PACK into the municipal waste stream. Check with your local solid
waste officials for details in your area for recycling options or proper disposal.
Safety Instructions
IMPORTANT
If you live in an area which receives frequent
thunderstorms, we strongly recommend plugging
your AC ADAPTOR into a surge protector.
7
PAUSE
RESIAL
EXAMPLE:
To store the number 1151968 under the TELEPHONE KEYPAD button:
1 - Press the button 4 - Press the TELEPHONE KEYPAD button.
2 - Dial 1151968. 5-You have stored 1151968 under TELEPHONE
KEYPAD button.
3-Press the MEMO button again.
A total of 10 telephone numbers can be programmed in memory.
IMPORTANT:
The maximum number of digits that can be stored for any phone number is 16 in
PULSE or TONE mode. The maximum number of digits for mixed (TONE and PULSE in
combination) dialing is 15. If you are using a switchboard system to access an outside line
(such as an 8 or 9), press the button to store a PAUSE.
Basic Operation
1
1
1
1
1
Recalling Stored Numbers from Memory
1. Press the PAUSE button.
2. Press the MEMO button.
3. Press the TELEPHONE KEYPAD button for the number you have stored. The stored number
will be dialed automatically.
EXAMPLE:
To recall number 1151968 stored under TELEPHONE KEYPAD button:
1- Press the button. 3- Press the TELEPHONE KEYPAD button.
2- Press the MEMO button.
Redial Feature
1. If you get a busy tone, press the button to hang up.
2. Later, press the button again.
3. Listen for a dial tone.
4. Press the button. This will automatically redial the last telephone number you called.
IMPORTANT
To obtain the best reception, be sure to
raise or reposition the BASE UNIT ANTENNA.
TALK
TALK
TALK
PAUSE
12
