Newco B-10-T3, Руководство по эксплуатации

Страница: 28 / 29

28
Service Notes
This machine uses advanced diagnostics to alert the operator should any of the
motors or motor controllers sense the motors are not turning at the correct rate or
sense a bad connection. These errors highlighted by a scrolling display such as
“Call for Service—(Left Auger) Motor Error”, and the Service Number entered
during machine set-up will be displayed. These Motor error messages include
Flipper Motor, Left and Right Auger Motors, Hot Water Bypass Pump, Water Pump
(for powder mix), Whipper Motor, and Air Pump.
Usually repairing a bad connection or replacing the indicated motor or pump will
remedy the problem.
Display Reads Possible Cause(s) Remedies Notes
Fill Timeout Water shut off to Machine Check Water Supply Shutoff
Initial fill time longer than 8
minutes
Supply Line Blocked or too small Repair or Replace as needed Fill time Longer than 1 Minute
Water Filter Restricted Replace-Service Req'd
Water Probe has a 30 second
Hysteresis cycle
Inlet Solenoid valve Faulty Replace-Service Req'd
Control Board Failure Replace-Service Req'd
Thermistor Error Thermistor not plugged in Make sure plug in housing is latched Open or Shorted Thermistor
Faulty Thermistor Replacement
Control Board Failure Replace-Service Req'd
Heater Timeout Faulty Thermistor Replacement
4 Minute Continuous Heater
Run
Faulty Heater Element Replace-Service Req'd
Control Board Failure Replace-Service Req'd
Motor Error Faulty wire connection Check connector/harness Auger Motors 24 v dc
Control Board Failure Replace-Service Req'd Water pump 12 v dc
Whipper motor 24 v dc
DRAINING THE HOT WATER TANK
THE DRAIN TUBE IS ATTACHED TO THE DRAIN CAP IN THE LOWER
REAR OF MACHINE. TANK HOLDS APPROX 1 US GALLON.
THE HOT WATER TANK CAN BE DRAINED FROM THE REAR OF THE
MACHINE –UNPLUG MACHINE FROM POWER SOURCE. CAUTION-
UNLESS THE TANK IS LEFT TO COOL THE WATER IS EXTREMELY
HOT AND CAN CAUSE HARMFUL BURNS. REPLACE DRAIN PLUG,
ENSURE HOSE CLAMP IS TIGHT AND REPOSITION DRAIN HOSE
CLAMP AND CAP BEFORE RE-FILLING THE HOT WATER TANK.